setting up sheetcam for a homemade plasma cutter

Some examples of specialist posts include machines with multiple heads, say a plasma cutter with a pucnch marking head. This service is normally free unless the post is particularly complicated. The programming language used is versatile enough to cope with pretty much anything you could possibly want a machine to do.Ĭustom posts can be written to your specifications. If you so wish you can create your own posts. Unlike many CAM packages the post format is freely available and documented. These can be fine-tuned to produce code for virtually any machine. To get over this, SheetCam comes with a wide variety of post processors. While G-code is theoretically a standard, most machines have their own dialects. Parts can be placed in an array to quickly fill a sheet with minimum effort. They can be flipped and rotated to make most efficient use of the material.

Peck drilling with controllable retract amount Ramp cutting to allow plunging with non center-cutting tools.ĭrill from circles or points in a DXF file SheetCam gives you many options to optimize cutting. Once you have defined you tool you can set up the cut. This increases consumable life and reduces faulty cuts due to blocked or obstructed nozzles Instead of plunging straight in, the cutter torch can ramp in, reducing the amount of material blown back into the torch. Draw your part the size you want and let SheetCam work out where to run the torch.Īutomatic cut ordering to ensure that inside contours are always cut before outside contours. You can define as many tools as you like for different materials etc. The tool definition allows you define all of the important parameters for cutting.

To load this tool set, open Sheetcam and click on File, then go down to open toolset and go to where you have it save from here and click on it and open the tool set and it should show up on the left side. SheetCam combined witn Mach3 and a torch height controller from CandCNC for an unbeatable plasma cutting solution. Here is a copy of the Tool Set that I made up for my Hypertherm 45xp. This is useful for machines running Mach3 for instance. SheetCam has many useful features for plasma, laser, waterjet and oxy-fuel cutting.įor machines that have full control over the Z axis you can program the pierce height and cut height directly.

Setting up sheetcam for a homemade plasma cutter